TMC2208 stepper driver + arduino

So, i’m trying to run a stepper motor (nema 17, 22mm) with a TMC2208 silent stepstick driver, but i don’t know where to start. I’m not strong in electronics but i read somewhere that you have to regulate a potentiometer on the board? Then i have to attach it to the arduino, in which way? (Planning to use an arduino nano) and i don’t even know what libraries it uses or how to program it. Does anybody have a hint? Not so much the programming (i’ll figure it out later) but just getting it to move, so i can test torque etc.

submitted by /u/LUMEN_s7
[link] [comments]